Yuku free message boards

Do you have to be a member to view videos? I get a generic 'welcome page'O w/ a log in...

Please do a full write up over at the 1MSPWG too!!!

When searching 'mdftaz' it says no results, but look down the page and it asks if you're looking for the user mdftaz, so I found your video.

WOWWW!!! I knew the door had to work!!! Good placement for the buttons too! When Mike was asking about schematics, I think some basic diagram or description of where things go and are wired up. I figure there's a single gear wheel affixed to the upper inside pivot. From there I've imagined a series of smaller gears working along the walls -which are spatially impractical; some form of pulleys, posssible, but still need straight lines to work and if any breaks, that's that; I've also pictured some kid of pulley on each side of the door, simply rotating on the upper pivot and not attached to it...

And then, where does the main gear box go? Under the seat? Is that the same motor for open and close functions and how do you get it to stop at the travel limit and not keep going? Is it possible to put the function buttons on the outside base, rather than the pod itself the way you have it wired? All these questions and more!

There is nothing about your build that is not entreily phenomenal and yet another bar has been set!!! Congrats! Looking forward t your finishing details!!!

2 !